howto: bind a transmitter and receiver

Procedure

1. power off receiver
2. power off transmiter
3. insert bind plug onto BAT pins
       - actually, I think it can go on to any pin
       - orientation doesn't matter, it just connect out neutral and control pins
4. power on receiver
       - light will blink
5. put transmitter throttle to zero position
6. toggle and hold bind switch on transmitter
7. power on transmitter
8. hold until binding is made
       - usually just a couple of seconds

Potential Problems

• plugging in servo, power connections into receiver backwards
• turning on transmitter first
• plugging in servo, power connections to wrong terminals