EastBay RC

Vito on RCGroups noted this item for use as a power distribution connector: I was looking around NAPA autoparts and saw this. The 16-1...

rinatka at rcgroups has an idea for light-weight power distribution for this setup: plush 6a, 18-11 2000kv motor, 5x3 prop.

Via the CrashCast , an interesting way to solder up a multi-ESC power distribution system by John Bernard.  It uses a short length of brass ...

Dontenorio69 has a nice power distribution "spider" wiring system documented on youtube.  Not only is it very nice, but his narrat...

As promised, here's an update on using a Wago 222-415 5-wire connector for power distribution. Executive summary: seems to work pretty...

Here's a nice power distribution harness by nanobug at the aeroquad forum.  Input is an EC5, outputs are 4 EC3's.

The Flying Breadboard : "Another small problem was the power distribution. We had to get power from 1 battery to 4 engines, so we creat...

DIY Drones : "First users need to put some soldering paste on center traces, this way we can drive currents over 40 Amps. Thickness ne...

RC Groups : "very simple : 2 or 4 pads on a pcb, minus from the battery on one (or two) positive on the other one (or two) and then all...

RC Groups post : "i am going to be using cncguns power distribution board since we are both using the same frame/quad setup/design. som...

ArduPirates build : "Ideally, the power distribution board should have been made like PCB's are usually done. But I did not want to...

kkmulticopter.kr :  $7.00 "Switch included.  Thickness: 1.6mm Switch slot length: 7mm  Hole distance: 45mm Weight: 12g This kit is ...

dalswede on rcgroups has a nice post on his quad .  Here's his XT60-based power distribution unit, future-proofed as he notes for a hex.

Here's a nice flickr set by Lenz Grimmer for his quad build.  He is distributing power using Wago connectors and credits Christof Glück...